94
94 | Maintaining and Transporting the Printer
Replacing the Paper Cutter
If you notice that your paper isn’t being cut cleanly, the cutter may need to
be replaced. You can obtain a new cutter (part number C12C815331). See
page 10 for ordering details.
Removing the Old Cutter
Make sure the printer is turned on, then follow these steps to remove the
blade:
1. Remove any paper from the paper path.
2. Press r
Menu.
3. Press d until
MAINTENANCE is highlighted, then press r.
4. Press d until CUTTER REPLACEMENT is highlighted, then press r.
5. When the screen displays
EXECUTE, press OK. The paper cutter moves
to the replacement position.
6. Turn off the printer.
7. To remove the cutter cover, press in the tab and pull it down.
Note: If the optional
SpectroProofer is
attached to the printer,
remove it following the
instructions that came
with it.
To Next Page
Loading...
