If anything is missing, contact Epson as described on the back.
Caution: Do not open ink cartridge packages until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
Unpack
1
Select your language
3
Press or to select your language, then press OK.
3 Flip the feeder guard forward, then squeeze the edge guide and
slide it left.
4 Load paper against the right edge and behind the tab, with the printable
side face up.
4 × 6
A4, Letter
Note: Don’t load the paper sideways; always load it short edge first.
5 Slide the edge guide over.
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the Encender/Ligar (On) button.
Note: You can raise the LCD display screen for better viewing, if necessary.
Turn on the printer
2
Install ink cartridges
4
Caution: Keep ink cartridges out of the reach of children and do not drink the ink.
Note: The ink cartridges that come with your printer have a lower yield due to the ink
system charging process. This process is carried out the first time you turn on your
printer and guarantees better performance.
Don’t load paper before installing ink cartridges.
1 Lift up the scanner, then open the cartridge cover.
2 Shake the ink cartridges gently 4 or 5 times, then unpack them.
3 Remove only the yellow tape from each cartridge.
Caution: Do not remove any other seals or the cartridge may leak.
4 Insert the cartridges in the holder for each color.
5 Press each cartridge down until it clicks.
6 Close the cartridge cover. Press down until it clicks.
7 Lower the scanner.
8 Press the OK button to charge the ink. Charging takes about 2 minutes.
Caution: Don’t turn off the printer while it is charging or you’ll waste ink.
1 Open the paper support and pull up the extensions.
2 Open the output tray, pull out the extensions, and raise the stopper.
Note: Do not raise the stopper for legal-size paper.
5
Load paper
Start Here
Please read these instructions before using the printer.
To Next Page
Need help?
General
