TM-T90 User’s Manual 7
English
Power Switch and Power Switch Cover
The power switch is on the front of the printer. Press it to turn on the
printer, and press and hold it for more than 3 seconds to turn off the
printer.
Power Switch Cover
You can use the enclosed power switch cover to make sure that the
power switch is not accidentally pressed. Peel off the backing tape
and press the cover into place to install it in the position shown in
the illustration below.
WARNING:
If an accident occurs when the power switch cover is attached,
immediately remove the bottom cover and unplug the power supply
cable to avoid fire.
Unpacking
The following items are included for the standard specification
printer. If any items are damaged, contact your dealer.
❏ Printer
❏ Roll paper
❏ Power switch cover
❏ Control panel label used for vertical installation
❏ Rubber feet (4) for vertical installation
❏ AC adapter (*)
❏ Usage Precautions for the Power Unit (*)
(*) May not be included with the printer
To Next Page
Loading...
Need help?
General
