Epson V11H735140 - Correcting Distortion (Image Warping)

a
When using the following lens, a message prompting you to
adjust the distortion (image warping) is displayed. After
adjusting the focus, adjust the distortion.
ELPLX01, ELPLU03, ELPLU04, ELPLW05, ELPLU02
s "Correcting Distortion (Image Warping)" p.37
c
Press the [Esc] button to finish the adjustment.
Correcting Distortion (Image Warping)
When using a short throw zoom lens and focusing at the center of the
screen, the surrounding image may warp and be out of focus. Follow the
steps below to correct the warping.
a
Press the [Focus] button on the remote control or the [Lens]
button on the control panel.
Repeatedly press the [Lens] button on the control panel until the
focus adjustment screen is displayed.
b
Press the [ ][ ] buttons to focus the image around the center of
the lens.
c
Press the [Focus] button on the remote control or the [Lens]
button on the control panel again.
Repeatedly press the [Lens] button on the control panel until the
distortion adjustment screen is displayed.
d
Press the [ ][ ] button to adjust the focus of the surrounding
area.
Installing the Projector
37