Epson WN7512BEP - Projecting with Quick Connection Mode; Projector Connection Standby Procedure; Initiating Computer Connection

12
Connecting in "Quick Connection Mode" and Projecting
Operating the Projector
Before connecting, put the projector into connection standby status.
A
Press the [t] button on the remote control to turn
on the projector.
B
Press the [EasyMP] button on the remote control.
The EasyMP standby screen is displayed.
Operating the Computer
In the following explanations, unless otherwise noted, Windows screens
are used. You see the same screens even when using Macintosh.
A
Start EMP NS Connection.
Select "Start" - "Programs" (or "All Programs") - "EPSON
Projector" - "EMP NS Connection".
Double-click the "Applications" folder of the hard drive volume in
which EMP NS Connection is installed, and then double-click the
EMP NS Connection icon.
B
Select "Quick Connection Mode" and then click
"OK".
The projector search results are displayed. To always connect using
"Quick Connection Mode", select "Set the selected Connection
Mode as the default mode for future connections".
Procedure
Procedure
For Windows
For Macintosh