-14-
LOADING INSTRUCTION
WARNING:
1)The product must not obstruct the display area completely.
2)Avoid leaving shelves empty so as not to create turbulence
wichmayprejudicregularrefrige-ratedairow,andcause
needless energy consumption.
3 cm
For the corect air circulation necessary to leave 3 cm free
space between the product and the bottom of each internal
shelf.
PUTTING INTO
OPERATION
Check that the voltage on the identication
plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO
WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED
BY A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE
GENERAL EARTHING PLANT.
The manufacturer disclaims all responsability for any damage
to people or things due to incorrect observance of this rule.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters
or multiple socket outlets to connect the counter. DIRECTLY
connect the equipment to the mains.
PERIODICAL MAINTENANCE
Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage. If the power supply cable is
damaged, don’t use the equipment and don’t try to repair it: to prevent any risk, it must be replaced by
the manufacturer, by a member of the after-sales service staff, or anyway by a person having similar
qualications.
In any case, none of the protective elements (the grill, the carter) must be removed by non qualied
staff. Absolutely avoid using the refrigerator without such protection.
The replacement of led lamps must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
WARNING! The appliance is intended for the SOLE storage of pre-
packaged products.
To Next Page
Loading...
Need help?
General
