Configuring QX IP PBXs with Flowroute
Revision 1.0 6 26-Sep-16
Figure 2: VoIP Carrier Wizard – page 2
3. On the third page of the VoIP Carrier Wizard define the Access Code (e.g. 1) which will be used in the
IP PBX Call Routing Table for making outgoing calls through the Flowroute, and the IP PBX extension
which will receive all incoming calls from the Flowroute SIP trunks (e.g. extension 00; it is the IP PBX's
default Auto Attendant). Routing all incoming calls to the Auto Attendant is the most frequently used
scenario. Defining another extension as the call receiver is also applicable.
Access Code – 1
Emergency Code – leave the default value or put your country emergency call
Route Incoming Calls to – 00.
4. Enable the Failover to PSTN service if it is desirable to allow calls failover through IP PBXs onboard FXO
lines or trunks (
N/A
on the QX2000) and press Next (Figure 3).
To Next Page
Loading...
Need help?
General
