EqualLogic PS Series - Page 6

PS Series 50E to 400E QuickStart Preface
vi
Organization
This QuickStart is organized as follows:
• Introduction to PS Series Storage Arrays
• Steps for Setting Up and Using an Array
Step 1. Set Up the Array Hardware Configuration
Step 2. Configure the Array and Create a Group
Step 3. Set the RAID Policy
Step 4. Create a Volume
Step 5. Connect to the Volume from a Host System
• Advanced Operations and More Information
EqualLogic Website
The EqualLogic website (www.equallogic.com) has the latest product
firmware and documentation, in addition to warranty information.
Product Documentation and Technical Support
For detailed information about PS Series storage arrays, groups, and volumes, see
the following documentation:
• Release Notes. Provides the latest information about PS Series storage arrays.
• QuickStart. Describes how to set up the storage array hardware and create a
PS Series group. Be sure to use the manual for your array model.
• Group Administration. Describes how to use the Group Manager graphical
user interface (GUI) to manage a PS Series group. This manual provides
comprehensive information about product concepts and procedures.
• CLI Reference. Describes how to use the Group Manager command line
interface (CLI) to manage a PS Series group and individual arrays.
• Hardware Maintenance. Provides information about maintaining the storage
array hardware. Be sure to use the manual for your array model.
• Online help. In the GUI, expand
Tools in the far left panel and then click
Online Help for help on both the GUI and the CLI. See Obtaining Online
Help on page 2-16.