55
EN
MANUFACTURER’S WARRANTY
The product is in compliance with EU norms and standards on low voltage guidelines and electromagnetic compatibility. We hereby declare
that the product complies with the provisions of Electromagnetic Council Directive 2014/30/EU, Low Voltage Directive 2014/35/EU and CE-
marking Directive 93/68/EEC. This certificate is issued following test carried out on samples of the product referred to above.
The manufacturer hereby warrants normal operation of the unit for 36 months after the retail sale date provided the user's observance of the
transportation, storage, installation, and operation regulations.
Contact the seller for warranty service. Defective parts under commercial warranty will be either repaired, or exchanged or reimbursed by
the seller.
The manufacturer’s warranty does not apply to the following cases:
• External damage to the unit casing (excluding external modifications as required for installation) and internal components caused by the
user.
• Redesign or engineering changes to the unit.
• Replacement and use of any assemblies, parts and components not approved by the manufacturer.
• Unit misuse.
• Violation of the unit installation regulations by the user.
• Violation of the unit control regulations by the user.
• Unit connection to power mains with a voltage different from the one stated in the user's manual.
• Unit breakdown due to voltage surges in power mains.
• Discretionary repair of the unit by the user.
• Unit repair by any persons without the manufacturer’s authorization.
• Expiration of the unit warranty period.
• Violation of the unit transportation regulations by the user.
• Violation of the unit storage regulations by the user.
• Wrongful actions against the unit committed by third parties.
OPERATION GUIDELINES
The fan is rated for connection to single-phase AC 220...240 V / 50 Hz power mains. Hazardous parts access and water ingress
protection rating is IP34.
The fan is rated for operation at the ambient temperature ranging from +1 °C up to +45 °C.
The unit is rated as a Class II electrical appliance.
ELECTRONICS OPERATION ALGORITHM
100 MM EXTRACTOR FAN SWITCHED ON BY A HUMIDISTAT 60%90%, +/5%. Stops automatically after reaching a humidity
level below the programmed maximum, and after the set time (between 2 and 30 minutes, +/-5%).
Make any necessary adjustments using the plastic screwdriver provided and refer to the diagram on page 58.
To Next Page
Loading...
