©2016 ETS Corporation | L5300 Installation and Configuration Guide
This information is CONFIDENTIAL and must be used exclusively for the operation of ETS software, hardware, or services. It
may not be duplicated, published, or disclosed without the express permission of ETS.
6. Insert the Ethernet cable into the LAN port
on your computer.
7. To activate the Equinox L5300, please call Customer Service at 1-800-834-7790.
2. Terminal Configuration
2.1 Setting up A New L5300 – Ethernet
1. Plug in the Ethernet cord. The cord
should go from the router to the
terminal, then from the terminal
into the computer.
2. Reboot the terminal either by tapping the small white button on the back left side of the terminal
or by un-plugging and plugging back the power cord.
3. Press Setup as soon as it appears.
To Next Page
Loading...
