Equus TT-WBC520 - Maintenance; Refilling Trimming Line; Air Filter; Fuel Filter

MAINTENANCE
1. In order to maintain your
product in proper working order,
perform the maintenance and
checking operations described
in the manual at regular
intervals.
2. Always be sure to turn off
the engine before performing
any maintenance or checking
procedures.
The metallic parts reach high
temperatures immediately after
stopping the engine.
3. Under no circumstances
should you ever take apart the
product or alter it in any way.
Doing so might result in the
product becoming damaged
during operation or the product
becoming unable to operate
properly.
HANDLING FUEL
1. The engine of the product
is designed to run on a mixed
fuel which contains highly
ÁDPPDEOHSHWURO1HYHUVWRUH
FDQVRIIXHORUUHÀOOWKHWDQN
of the unit in any place where
there is a boiler, stove, wood
ÀUHHOHFWULFDOVSDUNVZHOGLQJ
sparks, or any other source of
KHDWRUÀUHZKLFKPLJKWLJQLWH
the fuel.
2. Never smoke while operating
WKHXQLWRUUHÀOOLQJLWVIXHOWDQN
:KHQUHÀOOLQJWKHWDQN
always turn off the engine and
allow it to cool down. Take a
careful look around to make
sure that there are no sparks or
RSHQÁDPHVDQ\ZKHUHQHDUE\
before refuelling.
4. Wipe spilled fuel completely
using a dry rag if any fuel
spillage occurs during
refuelling.
5. After refuelling, screw the
fuel cap back tightly onto the
fuel tank and then carry the
unit to a spot 10feet (3m) or
more away from where it was
refuelled before turning on the
engine.
TRANSPORTATION
1. When hand-carrying the
product, cover over the cutting
part if necessary, lift up the
product and carry it paying
attention to the blade.
2. Never transport the product
over rough roads over long
distances by vehicle without
removing all fuel from the fuel
tank. If doing so, fuel might leak
from the tank during transport.
Maintenance, replacement, or
repair of the emission control
device and systems may be
performed by any non-road
engine repair establishment or
individual.
• Always be sure to stop the
engine before inspecting the
brush cutter for problems or
performing maintenance.
• Never alter the brush cutter or
take the engine apart.
• Things to check before using
brush cutter.
REFILLING TRIMMING LINE
For replacement line, use a
diameter of 3.0mm. The spool
is capable for a line up to 4m
on the head. Avoid using a
larger line as it may cut down
the trimming performance.
For safety reasons, do not use
metal reinforced line.
We recommend using Oregon
Duoline 3.00mm (part no.
106502E)
AIR FILTER
7KHDLUÀOWHULIFORJJHG
will reduce the engine
performance. Monthly check
DQGFOHDQWKHÀOWHUHOHPHQW
in warm, soapy water as
required. Dry completely before
installing. If the element is
broken or shrunk, replace with
a new one.
$LUÀOWHU
FUEL FILTER
When the engine
runs short of fuel supply, check
WKHIXHOFDSDQGWKHIXHOÀOWHU
for blockage.
)XHOÀOWHU
SPARK PLUG
6WDUWLQJIDLOXUHDQGPLVÀULQJ
are often caused by a fouled
spark plug. Periodically clean
the spark plug and check that
the spark gap is in the correct
range.
When you take off the spark
plug, twist and pull off the cap.
MAINTENANCE