54
Englisch
User Manual
h. CALIBRATION THE BREWING TEA LEVEL
After you turn on the kettle, hold down 3/3 tea level
button about 3 seconds without interruption, kettle
will pumping water into the teapot.
Please pump water up to the arrow mark ( ) on the
lter middle tube.
Thus, the 3/3 tea level will be the previous amount
again, and at the same time 1/3 and 2/3 tea levels will
be set automatically.
IMPORTANT NOTE:
If the Water runs up above the arrow mark while
performing the readjustment, there is a high probability
that the water will overow due to the swelling of the
stream in the strainer during pumping automatic.
To Next Page
Loading...