29
PLUG REPLACEMENT
If you need to replace the tted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Blue – Neutral Brown – Live
As the colours of the wire in the mains lead of this product may not correspond with the
coloured marking identifying the terminals in your plug, proceed as follows. The wire,
which is coloured blue, must be connected to the terminal, which is marked with N or
coloured black. The wire, which is coloured brown, must be connected to the terminal,
which is marked L or coloured red.
Connect
Blue to N
(neutral)
Outer sleeve
rmly clamped
Cable
grip
Brown L
(live)
13AMP fuse approved to BS 1362
WARNING!
Never connect live or neutral wires to the earth terminal of
the plug, which is marked with E.
Only t an approved 13 Amp BS1363 or BS1363/A plug and the correctly rated fuse. If in
doubt, consult a qualied electrician.
NOTE:
If a moulded plug is tted and must be removed take great care
in disposing of the plug and severed cable, it must be destroyed to prevent
engaging into a socket.
To Next Page
Loading...
