Erbauer EBPW3000 - Page 36

36
Problem Possible cause Solution
1. Machine does
not start.
1.1 Not connected to power
supply
1.1 Connect to a suitable
socket-outlet.
1.2 Supply cord or power
plug is defective
1.2 Contact your nearest
authorised service
centre.
1.3 Other electrical defect
to the machine.
1.3 Contact your nearest
authorised service
centre.
1.4 Trigger lock lever has
ippedup.
1.4 Flip the trigger lock
lever down.
1.5 Nozzle clogged. 1.5 Unclog the nozzle using
the cleaning needle.
1.6 Motor overheated. 1.6 Switch off and unplug
the machine. Let it cool
down for 10 minutes
and operate again.
2. Machine does
not reach full
power.
2.1 Extension cord not
suitable for operation
with this machine.
2.1 Use a proper extension
cord.
2.2 Power source (e.g.
generator) has too low
voltage.
2.2 Power source (e.g.
generator) has too low
voltage.
2.3 Air vents are blocked. 2.3 Clean the air vents
2.4 Water inlet volume is
too low.
2.4 Fully open the water
supply.
2.5 High pressure hose is
leaking.
2.5 Replace it with a new
high pressure hose.
2.6 Garden hose is leaking. 2.6 Replace it with a new
garden hose.
2.7 Inletlterheavilysoiled. 2.7 Cleantheinletlter.
2.8 Air being sucked into
the system.
2.8 Check tightness of hose
ttings.
2.9 Seals worn. 2.9 Contact your nearest
authorised service
centre.
5063022018892-EBPW3000-PressureWasher-UM-V03.indd 365063022018892-EBPW3000-PressureWasher-UM-V03.indd 36 09-11-2022 14:09:0809-11-2022 14:09:08
37
Problem Possible cause Solution
3. Water leaks
from the
connection/
from the
machine.
3.1 High pressure hose is
leaking.
3.1 Replace it with a new
high pressure hose.
3.2 Garden hose is leaking. 3.2 Replace it with a new
garden hose.
3.3 The O-ring on the water
inlet hose adapter is
broken.
3.3 Replace the water inlet
hose adapter with a
new one.
3.4 Seals worn. 3.4 Contact your nearest
authorised service
centre.
4. Strong
pressure
uctuations.
4.1 Nozzle clogged. 4.1 Unclog the nozzle using
the cleaning needle.
4.2 Water inlet volume is
too low
4.2 Fully open the water
supply.
4.3 High-pressure hose is
leaking
4.3 Replace it with a new
high pressure hose.
4.4 Garden hose is leaking. 4.4 Replace it with a new
garden hose.
4.5 Inletlterisheavily
soiled.
4.5 Cleantheinletlter.
4.6 Air being sucked into
the system.
4.6 Check the tightness of
hosettings.
4.7 Seals worn. 4.7 Contact your nearest
authorised service
centre.
5. Excessive
vibration/noise
5.1 Screws and nuts
loosened.
5.1 Check the fasteners for
tightness. Retighten as
necessary.
5.2 Motor damaged. 5.2 Contact your nearest
authorised service
centre.
5.3 Water inlet volume is
too low.
5.3 Fully open the water
supply.
5063022018892-EBPW3000-PressureWasher-UM-V03.indd 375063022018892-EBPW3000-PressureWasher-UM-V03.indd 37 09-11-2022 14:09:0809-11-2022 14:09:08
96456_IM_Erbauer 3000_EU.indb 3696456_IM_Erbauer 3000_EU.indb 36 2023/3/27 上午11:082023/3/27 上午11:08