31
1. Open the depth clamping lever (9) by hand.
2. Raise/lower the depth clamping lever (9) and set the blade to the required depth
as shown on the cutting depth scale (11).
3. Lock the depth clamping lever (9).
02
Laser (Fig. I)
Use the laser as guide when cutting on marked lines.
1. Switch the laser on by pressing the laser on/off switch (15).
2. Switch the laser off by pressing the laser on/off switch (15) again.
WARNING! Do not stare into the beam, class 2 laser product!
03
Switching on/off (Fig. J)
1. Shift the safety lock switch (3) backward to unlock the on/off switch (2).
2. Press the on/off switch (2) to switch the product on.
3. Release the on / off switch (2) to switch the product off.
04
Speed adjustment (Fig. K)
Adjust the speed depending on the application.
1. Turn the speed dial (21) left (as seen from operators position) to increase the
working speed.
2. Turn the speed dial (21) right (as seen from operators position) to decrease the
working speed.
650W Mini circular saw_MNL_EMCS650_TPS_GB_V02_V20518_20180604.indd 31 6/4/18 09:20
To Next Page
Loading...
