33
12. Keep the product moving at all times, do not stop in one position to avoid grooves.
13. Lift the product from the workpiece before switching it off..
02
Cutting metal
The product can be used for cutting metal, e.g. brass, copper, aluminium or galvanised
mild steel. Learn to use the tool by cutting wood before attempting to cut metal.
1. Always set the depth adjustment to at least 1 mm deeper than the material
thickness to avoid the blade riding up over the surface. Scrap material is required
underneath the work surface.
2. Remove burrs and rust as these impede the feed across the material.
3. Thick beeswax (furniture polish) applied to the base plate of the tool makes metal
easier to cut.
4. Every 2 minutes of metal cutting should be followed by a rest of at least 3 minutes.
WARNING! DO NOT use vacuum cleaner adaptor (16) or attach
vacuum cleaner for cutting metal! Pay attention to the hot metal dust
which comes out from the dust extraction outlet (17).
03
Cutting tiles etc.
1. Only use a blade specically designed for this purpose.
2. Always attach a suitable vacuum cleaner or dust extractor as the dust can be
hazardous to the operator and prevent the guard operating correctly.
After use
1. Switch the product off, wait for complete stop, disconnect it from the power supply
and let it cool down.
2. Check, clean and store the product as described below.
650W Mini circular saw_MNL_EMCS650_TPS_GB_V02_V20518_20180604.indd 33 6/4/18 09:20
To Next Page
Loading...
