EN
35
Use
Intended use
This device is intended for longitudinal and cross-cutting of solid wood, coated wood,
chip board, block board and similar wood like materials. Round work pieces may not
be sawed since they can be twisted by the rotating saw blade.
Only materials may be processed for which the corresponding saw blade is approved.
Only saw blades suitable for the device (HM saw blades) may be used. The use of
HSS saw blades and cut-off wheels of any type is forbidden.
Any other type of use is inappropriate. Improper use or modifications to the device or
the use of components that are not tested and approved by the manufacturer may
result in unforeseen damage!
Any use that deviates from its intended use and is not included in these instructions is
considered unauthorized use and relieves the manufacturer from his or her legal
liability.
Before you start
Controls
WARNING! Always switch the product off and disconnect it from power
supply before making any adjustments!
01
Protection
To Next Page
Loading...
