Erbauer ETS1500-A - Storage; Troubleshooting

EN
44
1. Switch the product off and disconnect it from the power supply.
2. Clean the product as described above.
3. Store the product in a dark, dry, frost-free, well-ventilated place.
4. Always store the product in a place that is inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
5. The table saw has two convenient storage areas (one on either side of the saw)
specifically designed for the saw’s accessories: push stick (16), blade wrench (20),
saw blade (26), rip fence (3), sub rip fence (2) and mitre gauge (22). When not in
use, store accessories securely. (Fig. AH)
6. The stand can be folded for storage. Return the balance bar to the inner side of
leg. Make sure the support bolt (66) is at highest position. Tighten all locking knobs
(38) of extension table. Loosen the locking knob (10). Step on the support frame
(13) and hold the transport handle to lift the table saw to its highest position. Pull
out the locking lever (18) completely and slowly fold the stand on the ground. Tighten
the locking knob (10) afterwards. Hold the transport handle to stand up the table
saw (Fig. AI) and move the table saw to the desired location.
Storage
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
Troubleshooting
1. Switch the product off and disconnect it from the power supply.
2. Press down on the side with “ON” on the brake pedal to unlock the transport wheels.
3. Grasp the transport handle firmly and raise the table saw up with two transport
wheels on the floor, then push the table saw to the desired location.
4. Press down on the side with “OFF” until the brake pedal is parallel to the floor to
lock the transport wheels.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualified specialist if you
cannot solve the problem yourself!