What to do if one or more UV high pressure lamps in my ergoline Avantgarde 550 Tanning Beds do not light up?
If one or more UV high pressure lamps do not light up, first ensure the UV high pressure lamp is correctly inserted in the socket. If it is properly inserted, the UV high pressure lamp may be defective and need replacement. Another potential cause is a defective igniter, which would also need to be replaced.
What to do if my ergoline Avantgarde 550 gets too hot?
If the unit is getting too hot, the filter mats may be dirty, and the ventilation of the cabin may be insufficient. Replace the filter mats.
What to do if one or more UV low pressure lamps in my ergoline Avantgarde 550 do not light up?
If one or more UV low pressure lamps do not light up, ensure the UV low pressure lamp is correctly inserted in the socket. If the lamp is properly inserted, it may be defective and require replacement.
Why UV low pressure lamps and fans do not turn on when operating the timer/control of my ergoline Avantgarde 550?
If the UV low pressure lamps and fans do not turn on when the timer/control is activated, there may be no power available. Check if the fuse/residual current circuit breaker is switched on.
How to fix flickering UV low pressure lamps in ergoline Avantgarde 550?
If the UV low pressure lamps are flickering, the starter may be defective. Replace the starter.
What to do if the top part of my ergoline Avantgarde 550 does not remain in the upper or lower position?
If the top part does not remain in the upper or lower position, the lifting mechanism may be incorrectly adjusted. Adjust or release the springs of the lifting mechanism.
General| Model | Avantgarde 550 |
|---|---|
| Category | Tanning Beds |
| Number of Lamps | 48 |
| Session Time | 20 minutes |
| Air Conditioning | Yes |
| Body Ventilation | Yes |
| Stereo Sound System | Yes |
| Voltage | 400 V |
| Frequency | 50 Hz |
| Timer | Yes |
| Cooling System | Yes |
| Power | 5500W |
To Next Page