What to do if one or more UV high pressure lamps in my ergoline Avantgarde 600 do not light up?
If one or more UV high pressure lamps do not light up, first ensure the UV high pressure lamp is correctly inserted in the socket. If it is properly inserted, the UV high pressure lamp may be defective and need replacement. Another potential cause is a defective igniter, which would also need to be replaced.
What to do if my ergoline Tanning Beds gets too hot?
If the unit is getting too hot, the filter mats may be dirty, and the ventilation of the cabin may be insufficient. Replace the filter mats.
What to do if one or more UV low pressure lamps in my ergoline Avantgarde 600 do not light up?
If one or more UV low pressure lamps do not light up, ensure the UV low pressure lamp is correctly inserted in the socket. If the lamp is properly inserted, it may be defective and require replacement.
Why UV low pressure lamps and fans do not turn on when operating the timer/control of my ergoline Tanning Beds?
If the UV low pressure lamps and fans do not turn on when the timer/control is activated, there may be no power available. Check if the fuse/residual current circuit breaker is switched on.
How to fix flickering UV low pressure lamps in ergoline Avantgarde 600?
If the UV low pressure lamps are flickering, the starter may be defective. Replace the starter.
What to do if the top part of my ergoline Tanning Beds does not remain in the upper or lower position?
If the top part does not remain in the upper or lower position, the lifting mechanism may be incorrectly adjusted. Adjust or release the springs of the lifting mechanism.
Defines the intended use of the sunbed for tanning one adult person.
Provides general safety instructions and warnings for operation.
Lists important safety rules for tanning.
Provides specific tanning times for different skin types and sessions.
How to access and use the sunbed's service mode.
Lists recommended intervals for replacing wearing parts.
Step-by-step guide for cleaning/changing UV lamps in the base.
Instructions for cleaning/changing UV lamps in the shoulder tanner.
Guide for cleaning/changing UV lamps in the sunbed canopy.
Steps for cleaning and changing high-pressure UV bulbs.
Steps to remove and change filter mats in the canopy.
Lists fault codes displayed on the unit and their meanings.
Details common faults, their causes, and remedies.
General| Type | Tanning Bed |
|---|---|
| Max Session Time | 20 minutes |
| Weight | 250 kg |
| Cooling System | Body ventilation plus, Facial ventilation |
| Facial Tanner | Yes |
| Shoulder Tanner | Yes |
| Air Conditioning | Yes |
| Body Ventilation | Yes |
| Stereo Sound | Yes |
| Frequency | 50 Hz |
| Voltage | 400 V |
| Control System | Digital |
| Lamps | 160W |
| Timer | Digital |
To Next Page