Ergotron WorkFit-P - Step 2: Arm Installation

Adjustment StJ!p
Important! Yo~ will need to adjust this product after installation is complete.
Make sure all xour equipment is properly installed on the product before
attempting ad~ustments. This product should move smoothly and easily
through the fyll range of motion and stay where you set it. If movements are
too easy or difficult or if product does not stay in desired positions, follow the
adjustment in~tructions to create smooth and easy movements. Depending on
your product 9nd the adjustment, it may take many turns to notice a difference.
Any time equi~ment is added or removed from this product, resulting in a
change in the '(veight of the mounted load, you should repeat these adjustment
steps to ensur~ safe and optimum operation.
!
I
- I
Increase Lift Strength
If the mounted weight is too heavy or this product does not stay up
when raised, then you'll need to increase Lift Strength:
a
Decrease Lift Strength
If the mounted weight is too light or this product does not stay
down when lowered, then you'll need to decrease Lift Strength: