Item no: 07488
Assembly
This ramp was designed with the sportsman in mind. It is ideal for loading and unloading snowmobiles and
ATV’s. This is a perfect all-season ramp, with easy installation of the polyethylene runners.
To remove the polyethylene runners please follow the directions below:
1. Use a Phillips ( ) screwdriver to remove self tapping screws.
2. Polyethylene runners can now lift-off easily. Store the screws and runners in safe location.
Step 1 Be sure you are loading on a hard, level and stable surface and that the vehicle you are loading
into is parked with the emergency/parking brake in “Park” and the engine is “off”. Unfold and place the
lip of the ramp against the back of the vehicle.
Step 2 Secure the ramp to the vehicle using the strap. When the strap is secure, test the ramp by
pulling backward on it. Ensure that the ramp does not slide back or disengage from the
loading surface.
Step 3 Once the ramp is secure and the area is safe to proceed with loading, move the vehicle to be
loaded between the ramps and center the load.
Step 4 Proceed with loading the vehicle, making sure the ramp is sustaining the load and not
bowing from weight.
Step 5 Continue until the vehicle is fully loaded. Secure the brake and tie down as needed.
Step 6 Unhook the chain and fold the ramp and lock into the folded position. Store in a clean, dry and
safe place where damage will not occur.
Usage
Specifications
Rated Capacity
1500 lb. (distributed load)
(Open) 84” x 54” (Folded) 5.75” x 84” x 18.5”
Ramp Dimensions
To Next Page
Loading...
