Ericsson 5780 - Install Gateway; Wall Mounting Procedures

Unlicensed LPWA Gateway 5780
1/1553-KRC 161 673 UEN Rev PB9 2017-03-24
 Ericsson AB 2017
17 (45)
Commercial in confidence
6 Install Gateway
6.1 Wall Installation
6.1.1 Using Support 6501
The drilling overview for wall installation is shown below
Figure 13 Drilling Overview for wall installation
Steps
To install the gateway using a wall installation, do the following
1. Mark a hole in the wall for the upper hole
position on the gateway, and drill a hole. The
size and type of drill are specified in the site
installation plan. The maximum screw diameter
size is 6 mm.
Note: Wear protective equipment when drilling