Unlicensed LPWA Gateway 5780
1/1553-KRC 161 673 UEN Rev PB9 2017-03-24
6.1.2 Using Wall plate
The drilling overview for wall installation is shown below
Figure 14 Drilling Overview
Steps
To install the gateway using a wall installation, do the following
1. Mark a hole in the wall for the upper hole
position on the gateway, and drill a hole. The
size and type of drill are specified in the site
installation plan. The maximum screw diameter
size is 6 mm.
Note: Wear protective equipment when drilling
2. Insert a plug or an expander bolt into the
hole. Plugs or expander bolts are not
delivered with the unit. They must be
specified by the site installation plan.
3. Insert a screw in the hole, leaving
10 mm of the screw pointing out from the
wall. Use a flat washer.
4. Hook the Wall Plate onto the screw.
To Next Page
Loading...