Installing the AP 6120
Figure 2 Power over Ethernet
Warning!
If PoE is used, the AP 6120 must be connected to a power source that complies
to IEEE 802.3af or 802.2at, or to an IEC/EN 60950-1 compliant power limited
source.
2.4 Step 4—Check LEDs
After powering on, wait 2 minutes and check that the unit’s LED match those in
Table 2.
Table 2 LED Behavior
LED Behavior
POWER Blue
2.4G Blue
5G Blue
INTERNET Blue or flashing blue
If the LED behavior does not match Table 2, refer to the Access Point User
Guide, 1/1553-LZA 101 806.
8
1/006 92-LZA 101 810 Uen A | 2013-04-11
To Next Page
Loading...
