Glossary
second_p_tag: 0
tag: transparent
second_tag: untagged
tags: all
flow_selection_criteria: none
second_tags: untagged
filter_profile: none
Command Usage
The command is used to connect a port with a switching domain. Instead of
specifying an Ethernet port, a host port can be specified using the command
connect host_port. Note that if no bandwidth_limitation is allocated, the
bandwidth limitation function will not be activated for the connection and the
connection has unlimited bandwidth.
It is possible to configure the switching domains in the EFN324 to have one or
two VLAN tags (QinQ) attached.
The QoS type for the individual flows of a switching domain may be specified
using this command.
Example:
efn# connect vlan 2 ethernet_port 2 egress p_tag
transparent broadcast_allowed
efn# connect vlan 2 ethernet_port 2 egress tags
3,4,untagged
efn# connect vlan 2 ethernet_port 2 egress tags *,untagged
efn# connect vlan 2 ethernet_port 2 egress tags 20-35
13.8.7 disconnect vlan
Use this command to disconnect a port from a specified switching domain (the
first command in Syntax) or to disconnect a port from all switching domains
(second and third command in Syntax).
To Next Page
Loading...