IndexIndex
Caution!
Burst tolerance values that are set lower than the default values may
cause too strong a limitation of the flow.
Example:
efn# set bandwidth_limitation 12 bandwidth 12000
burst_tolerance auto
13.8.9 set connection
Use this command to configure specific attributes that may be associated with
a connection between a switching domain and an Ethernet port. See also add
connection in section 13.8.1 on page 107. Use the command reset
connection to reset to default values and unset connection to reset to
undefined values.
Syntax
set connection vlan <vlan> ethernet_port <port>
[multicast_group_limit <groups>]
[option_82_remote_id <remote-id>]
[option_82_circuit_id <circuit-id>]
unset connection v
lan <v
lan> et
hernet_port <por
t>
static_multicast_groups
Arguments:
vlan <vlan> - The number of the Switching Domain. Range 1 to 200.
ethernet_port <port> – The number of the Ethernet port. Range 1
to 26.
multicast_group_limit <groups> - Maximum number of
simultaneously active multicast streams, that is, how many streams can be
‘joined’ at a certain point of time. This parameter is defined using set or
unset commands. Range 1 to 100 or undefined.
option_82_remote_id <remote-id> - Content of remote ID
Suboption to be used for Option 82. This parameter is used when
To Next Page
Loading...