Annex: PC data configurations
Windows 98 GPRS set-up
Warning!: your PC must have the Dial-up
Networking and the TCP/IP protocol installed
within the network components. You can check this
in ‘Start->Settings->Control Panel’ and double
clicking on ‘Network’. If not, these components
have to be previously added from your Windows
installation disk.
To configure your GPRS connection under Windows
98 in your PC, follow steps 1 to 9:
1) Go to ‘My Computer’ and double-click ‘Dial-Up
Networking’.
2) Double-click on ‘Make New Connection’ so that
the wizard starts. Type a name for the connection
and select the installed analog modem from your
computer, then click on ‘Next’.
3) In the ‘Telephone number:’ field enter: *98#, then
click ‘Next’.
Annex: PC data configurations 41
To Next Page
Loading...