You have now installed the GPRS connection. To
connect to the GPRS network, follow steps 1 to 3:
1) Go to ‘My Computer’-> Dial-Up Networking’ and
open the previously configured connection.
2) Type the user name and password provided by
your network operator and verify that the
telephone number is *98#. Then press ‘Connect’.
3) Once you are connected, you may use your
connection as an ordinary Internet connection.
Note: if your network operator has provided you with
a Proxy Address, you should configure your Web
browser (Internet Explorer, Netscape, etc.)
accordingly.
Windows NT GPRS set-up
Warning!: your PC must have the Remote Access
Service and the TCP/IP protocol installed within the
network components. You can check this in ‘Start-
>Settings->Control Panel’ and double clicking on
‘Network’. If not, these components have to be
previously added from your Windows installation disk.
44 Annex: PC data configurations
To Next Page
Loading...