To configure your GPRS connection under a
Windows NT PC, follow steps 1 to 8:
1) Go to ‘My Computer’ and double-click ‘Dial-Up
Networking’.
2) If there are no previously configured connections,
the following wizard will show up. Type a name
for the connection and tick ‘I know all about
phonebook entries and would rather edit the
properties directly’. Then click on ‘Finish’; edit
properties of this new connection and go to step 4)
to continue with the configuration.
3) Instead of the wizard window, the following
window might come up. In this case, push
‘New…’ button.
4) Within the ‘Basic’ tab, type a name for the
connection in the ‘Entry name’ field. In the ‘Dial
using’ field select the analog modem already
installed on your PC.
Annex: PC data configurations 45
To Next Page
Loading...