PC Data Configurations
Fixed Wireless Terminal: G32 and G36 models 41
Windows™ NT/2000 EDGE/GPRS set-up
Note: Your PC must have the Remote Access Service and the
TCP/IP protocol installed within the network components. You can
check this in ‘Start->Settings->Control Panel’ and double clicking
on ‘Network’. If not, these components have to be previously
added from your Windows™ installation disk.
To configure your EDGE/GPRS connection for a PC with Windows™
NT/2000 as operating system, follow the provided steps:
1. Locate and double-click on the My Computer icon located on your
desktop.
2. Locate and double-click on the Network and Dial-Up Connections
icon.
3. With the Dial Up Networking screen displayed, double-click on the
Make New Connection
Make New ConnectionMake New Connection
Make New Connection option.
4. With the Location Information screen displayed:
• Select the country or region that you are situated in from the
What country/region are you in now?
What country/region are you in now?What country/region are you in now?
What country/region are you in now? option.
• Specify the area or city code as well as the number you need to
dial when you access an outside line, if it is required.
• Select whether your phone system uses Tone or Pulse dialing.
To Next Page
Loading...