Ericsson G32 - Page 55

Web-based Configuration
Fixed Wireless Terminal: G32 and G36 models 55
• Enabled only for voice calls
• Enabled only for fax calls
• Enabled only for data calls
• Enabled only for fax and data calls
As default “Enabled, all incoming calls” is selected
Ringing signal sequence
This provides the possibility of setting different ringing sequences
depending on the incoming call’s nature. By default the four possibilities
are set to be the same as when receiving a regular voice call. The four
different ringing types are defined on the line parameters setting stored in
the FWT during the manufacturing stage.
Ringing signal defined
Ringing signal used for regular incoming voice call.
Line 2 ringing signal defined sequence
Ringing signal used for ALS (Alternate Line Service) activated and calls to
line 2.
Fax ringing signal defined sequence
Ringing signal used for incoming fax call.
Data ringing signal defined sequence
Ringing signal used for incoming data call.