Troubleshooting
62 Fixed Wireless Terminal: G32 and G36 models
Audible Tones
The FWT generates audible tones in your telephone set, thus providing
the same service characteristics as the one given by the traditional fixed
line network.
The following table describes the nature of the main tones you will get
when using the unit. Other standard call progress tones, such as busy
tone, number obtainable or ring back tone, are provided directly by the
network.
Note: Some tones can vary depending on your network operator.
Tone Name Nature It means...
1 Dial
Regular tone when picking
up the phone
The phone is in service and you
can start your call.
2 Special dial
Intermittent long-cadenced
tone when picking up the
phone
The phone is in service and you
can start your call, but you have
some subscriber service (call
forward, barring or hot line)
activated.
3 No service
Intermittent short-cadenced
tone when picking up the
phone
No service available. Refer to
Troubleshooting on page4.
4 Howler Loud and acute tone
You have left the handset lifted for
too long without any call in
progress.
5
Minute
minder
1 beep every minute while in
conversation
It tracks the duration of the call.
6
Voice mail
alert
When picking up the phone,
three beeps and then
regular tone
You have a voice mail in your
voice mailbox. You need to call
your mailbox to retrieve it. Refer
to the topic Voice Mail on page 4.
7 Positive 1 beep
Subscriber service successfully
activated or positive interrogation
indication.
8 Negative 3 beeps Negative interrogation indication.
9 Error 1 deep tone
Subscriber service not activated
or programming procedure not
successfully performed.
To Next Page
Loading...