PRELIMINARY
Technical Description
Alarm notifications can be enabled or disabled for the entire system (terminal).
Disabling alarm notifications means that no new alarm or event notifications
are sent to the management system.
For a list of replaceable HW parts, see Section 7.6 on page 44.
Fault management for Ethernet is described in Section 4.7 on page 26.
7.5 Performance Management
7.5.1 General
The purpose of Performance Management for the
packet radio is to monitor the
performance of
the Ethernet interface and the RF interface.
Performance data is stored in a volatile memory, so that a restart will lose
all gathered data.
7.5.2 Radio Link Performance Counters
The following table shows the performance counters that are monitored:
Table 4 Performance Counters, their Respective Counting Intervals, and the Type of Data
Stored in the NE
Performance counter
Counting Intervals
Data stored in the NE
RF input power 15 minutes intervals The counters for the current
15 minutes and the previous
96×15 minutes
RF output power 15 minutes intervals The counters for the current
15 minutes and the previous
96×15 minutes
42 1/22102-HRA 901 17/9 Uen PU1 | 2016-07-04
To Next Page
Loading...
