PRELIMINARY
Technical Description
The Ethernet and PoE cables are connected to the injector using shielded
RJ45 connectors.
There are two versions of the injector: one for AC power supply and one for
DC power supply.
Power supply requirements for the AC version:
Input Voltage: 100 to 240 V AC
Input Current:
1A
Frequency:
50 to 60 Hz
Power supply requirements for the DC version:
Input Voltage:
30 to 60 V DC
Input Current:
1A
8.1.2 Power Over Ethernet Cable
One Ethernet cable can supply the packet radio with Ethernet payload, in-band
DCN, and DC-power. The cable has an angled, environmentally sealed, RJ45
connector on the end that is connected to the packet radio, and a standard
RJ45 on the other.
17254
Figure 25 Power over Ethernet Cable
52
1/22102-HRA 901 17/9 Uen PU1 | 2016-07-04
To Next Page
Loading...
