erlab Halo Smart - General Description; Safety notices; Product registration

User Manual
3
General Description
Halo safely captures chemicals of the ambient air before recirculating clean air back into the laboratory.
Easily mounted into the ceiling, HALO is totally independent of the building ventilation system.
Utilizing the power of Erlab’s advanced carbon ltration technology, Halo retains a broad range of noxious chemical vapors
while simultaneously improving the air quality of the lab.
The exclusive sensor technology continuously evaluates the laboratory air quality and can be set according to the laboratory
pollution (please check Halo’s operating mode on page 17 and sensor settings on page 19 to determine the best use for
your laboratory).
When Halo senses contaminants, the soft LED lights will pulse to let you know that the air is being cleaned.
The usage and the management of each unit is possible via an embedded webportal from a smartphone, tablet or computer.
Safety notices
The effectiveness of this device is directly dependent upon correct use and monitoring.
The equipment provided is not intended to be used in an explosive atmosphere.
Keep away from any risk of liquid splashes.
Do not installed outside of the laboratory.
Sensor replacement:
VOCs sensor: every 5 years (semiconductor sensor)
Acids (A) and Formadehyde (F) sensors: every 2 years (electrochemical sensors)
After the usage time, Erlab cannot guarantee its stability and performance.
Product registration
Take full advantage of the device’s connectivity to enhance your safety
Get up to 10 years warranty on your connected Erlab unit
Register your product online: the registration of the product will automatically give you one extra year of warranty (in addition
to the warranty mentioned in the Erlab’ general terms and conditions of sale).
Connect your unit: Once the device is connected to the Internet and congured to exchange usage data, the warranty is
extended for up to 10 years. Warranty will be successively renewed at each lters replacement and/or or at the end of lter
usage time.
In order to benet from Erlab extension of warranty offer, the following conditions shall be respected:
Warranty applicability is subject to the respect of the Erlab’ general terms and conditions of sale and following requirements:
• The registration and/or the connection of the product shall be performed within the twelve months from the purchase date;
• Filters replacement must be performed following recommendations or at the end of lter usage time ; The lter’s serial
number, used as an identication key, validates this condition, regardless of your device’s supplier (and/or the
replacement lter’s supplier for the following years);
• The device’s replacement lters must be manufactured by Erlab, as must all other spare parts.
Consumables such as lters and saturation sensors are not covered under warranty.