Installation, Optional Sound Control
Disclaimer: This phase of the installation involves modification of the Sound Board.
Done incorrectly, the board may be irreparably damaged. Proceed at your own risk!
The Electric Railroad Company does not warranty this modification, and any damage
done by making this modification is the sole responsibility of the user.
• Included in the kit is a 4-pin connector with one wire. This wire is a sound trigger signal
that works by injecting a DC offset into the convention sound systems. When this
connection is made, the injected signal makes the sound system think it has a DC offset,
thus it activates.
• This Picture shows the connection to be made on the conventional sound system in this
locomotive. Contact support@electricrr.com
for help with other sound systems. There
are also some sound system connection examples in the AC/DC Commander manual
available on-line.
7
To Next Page
Loading...