These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principles
of operation and safe practices for electric welding equipment, we urge you to read our booklet,
"Precautions and Safe Practices for Arc Welding, Cutting and Gouging." Form 52-529. Do NOT permit
untrained persons to install, operate, or maintain this equipment. Do NOT attempt to install or operate
this equipment until you have read and fully understand these Instructions. If you do not fully
understand these Instructions, contact your supplier for further information. Be sure to read the
Safety Precautions on page 2 before installing or operating this equipment.
MIGMASTER 250
WELDING PACKAGES
Be sure this information reaches the operator.
You can get extra copies through your supplier.
F-15-087-E
NOTE: This manual is also suitable for use with L-TEC Migmaster 250 package.
INSTRUCTIONS for
F-15-087-E
August, 1997