18
Troubleshooting
OPERATION IN CASE OF EMERGENCY
In the event of an emergency you should:
• Switch o all controls.
• Switch the washing machine o at the power point or at the fuse box.
• Call the Residentia Support Team on 1300 11 HELP (4357).
Some minor faults can be xed by referring to the instructions given in the Troubleshooting section
below. There is also a self-help section online at https://support.residentiagroup.com.au/
DESCRIPTION SOLUTION
Display is not on
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected program.
• Press the On/O button.
"FUL" Displays
• Check the water container. If it's full, please pour out the condensate water
and restart the dryer.
• If the container is not full, please restart the dryer.
• If the “FUL“ icon is still lit after you have nished the rst two steps, please
contact the after sales service team.
" " Displays • Clean the lint lter.
Dyer does not start
• Connect the dryer to the mains.
• Turn on the tumble dryer.
• Check the door is closed.
• Check the program is set.
• Press the Start/Pause button.
Degree of dryness was not
reached or drying time too
long
• Clean lint lter and .
• Empty the water container.
• Check the drain hose.
• Check installation place is appropriate.
• Keep the air inlet clean.
• Use higher drying intensity level program or time program.
There are humming noises
• The compressor is operating. These noises are quite normal and do not
indicate a fault.
The dryer switches o at the end
of the program
• This is normal operation. The dryer will switch o automatically for
energy saving
18
OPERATION
Child lock
Remaining Time indicator/Error message
Clean filters (warning)
Intensity
My Cycle
Display
Delay
Anti-crease
To Next Page
Loading...
