ESCALADE EXT 2008 - MEMORY SETTINGS; Easy-Exit Seat; REMOTE VEHICLE START

E S C A L A D E E X T
Customization features include:
• Display in English
• Display Language
• Auto Door Lock
• Auto Door Unlock
• Remote Door Lock
• Remote Door Unlock
• Delay Door Lock
• Exit Lighting
• Approach Lighting
• Chime Volume
• Park Tilt Mirrors
• Easy Exit Seat
• Memory Seat Recall
• Remote Start
• Display Digital Speed
• Factory Settings
• Exit Feature Settings
MEMORY SETTINGS
The memory
buttons are
located on the
driver’s door.
Settings for two
drivers can be
programmed
for the driver’s
seat, outside mirrors and
adjustable pedals.
To save memory settings:
1. Adjust the driver’s seat,
outside mirrors and pedals to
a comfortable position.
2. Press and hold button 1 or 2
until two beeps sound.
Repeat these steps for a
second driver.
To recall the settings, press memory
button 1 or 2 with the vehicle in
Park. If the Remote Keyless Entry
(RKE) transmitter is used to enter
the vehicle and the memory seat
recall feature is turned on in the
DIC (see Vehicle Customization
Settings), the settings will be
recalled automatically.
Easy-Exit Seat
The (Easy-Exit) button is located
between the two memory buttons. If
the easy-exit feature is turned on in
the DIC (see Vehicle Customization
Settings), the driver’s seat will
automatically move rearward a
predetermined amount when the key
is removed from the ignition. To
move the seat back completely,
press the easy-exit button.
REMOTE VEHICLE START
This feature allows you to start the
engine from outside the vehicle by
using the Remote Keyless Entry (RKE)
transmitter. (Remote Vehicle Start
transmitter range is approximately
200 feet, with the vehicle in a direct
line of sight.)
After a remote start, the engine will
run for about 10 minutes before
turning itself off, but can be
extended 10 minutes by performing
another remote start sequence at any
time. After two consecutive remote
starts, no additional remote starts are
allowed until the vehicle has been
started with the ignition key.
The vehicle’s climate control system
will automatically heat or cool the
vehicle interior to 74°F (23°C), and
adjust the airflow to the defrost
or vent mode depending on
ambient conditions.
NNoottee::
The two RKE transmitters are
specifically synchronized to either memory
button 1 or 2. If the correct memory
settings are not recalled, try using the
other RKE transmitter.