6
1. Setting & adjusting the
thermostat
1.1 Setting the Temperature
To set the temperature, turn the dial until the desired tem-
perature is shown in the LED display. The LED display will flash
the desired temperature for (approximately) 5 seconds before
returning to display the current room temperature.
1.2 Setting TPI
TPI is usually set up during installation. To adjust the setting
after installation, simply click the unit off the backplate (See
section 2.1 for details) and move the DIP switch on the rear of
the unit to TPI (See section 4.2.3 for details). Refer to Section
2.2 to click the unit back into place.
1.3 Setting Delayed Start
Delayed Start is usually set up during installation. To adjust
the setting after installation, simply click the unit off the back-
plate (See section 2.1 for details) and move the DIP switch
on the rear of the unit to Delayed Start (See section 4.2.3 for
details). Refer to Section 2.2 to click the unit back into place.
To Next Page
Loading...
