Esko Kongsberg i-XL - User Manual

Service Guide
i-XL
Kongsberg XL / i-XL tables
Note
We remind you that only the Esko staff, or persons having received
appropriate training, are allowed to handle, manipulate or do repairs on the system.
A Publication of: Esko-Graphics Kongsberg AS
Copyright © 1984-2013 Esko.
This copyright does not indicate that this work has been published.
All rights strictly reserved. Reproduction or issue to third parties in
any form whatever is not permitted without written authority from the publisher.
Esko reserves the right to change specifications without notice.
Document number: D3073
Status: 110905
Esko-Graphics Kongsberg AS
www.esko.com
P.O.Box 1016, N-3601 Kongsberg, Norway
Tel: +47 32 28 99 00 Fax: +47 32 28 85 15 / 32 28 67 63
not permitted without written authority from the publisher.

Summary

Comparing i-XL to Standard XL

i-Cut User Interface

Details the i-Cut software package used as the user interface for the i-XL system.

The i-Cut Computer Stand

Describes the i-Cut computer stand, its components, and its placement on the i-XL table.

The i-Cut Camera

Explains the i-Cut camera function for reading register marks and its connection.

The Main Reference Point Position

Set the Main Reference Point for i-Cut

Outlines the procedure to set the main reference point specifically for i-Cut operation.

Set the Main Reference Point on a Table with Rulers

Details how to set the reference point using rulers, differentiating between XL-Guide and i-Cut setups.

Software Installation

Install XL-Guide

Instructions for installing the XL-Guide software on the front-end PC.

Install i-Cut Hardware and Software

Steps required before and during the installation of i-Cut hardware and software components.

How to Update the i-Cut License Codes

Procedure for updating i-Cut license codes and enabling new options.

Configure XL-Guide for i-Cut Control

Specifies the necessary XL-Guide settings for proper i-Cut integration.

Configure i-Cut for the Kongsberg i-XL

Details the system settings within i-Cut for the Kongsberg i-XL table.

How to Check Camera Operation

The Kiss-Cut Knife Tool

How to Glue the Belt

Belt Glue Procedure (November 05, 2007)

Details a simplified method for cutting and gluing the belt.

Old Belt Glue Procedure

Presents an older procedure for gluing the conveyor belt, including necessary tools.

Sheet Feeder Operations

Sheet Feeder Setup Parameters

Details the various parameter settings for configuring the sheet feeder operation.

Appendix 1: i-Cut Production Settings for Kongsberg

Appendix 2: Verify and Adjust Table Angle with Conveyor Belt

Esko Kongsberg i-XL Specifications