1. Stem plate bolt removal 2. Tightening stem plate bolts.
STEP 1. Install the Handlebars
Assembling Your Bike
Note: DO NOT depress the brake levers before
installing the front wheel.
1. Using the Allen wrench, unscrew the 4 bolts and remove
the stem plate.
2. Place your handlebars into the groove and replace the
stem plate over the top. Tighten the bolts about 3/4this
of the way.
3. Make the nal adjustments on your handlebars position,
ensuring that they are centered and at a comfoable angle
before tightening the bolts the rest of the way.
Before assembling, check that all pas are complete and
in good condition. If you have any questions or cannot
nd the information you need in the manual, please
contact at suppo@eskute.com.
NOTE:
03
To Next Page
Loading...