What to do if the Espina Water System motor does not start?
If the motor of your Espina Water System doesn't start, there are several potential causes. First, check the mains voltage to ensure it's sufficient. Also, inspect the mains current fuse to confirm it's in the 'on' state. Finally, the pump wheel might be blocked, in which case you should dismount and clean the pump.
Why does my Espina ESP050 have no suction in the pump?
If your Espina Water System pump has no suction, it could be due to several reasons: * The suction valve may not be submerged in water – ensure it is. * There might be no water in the pump – fill it with water. * There could be air in the suction pipe – check the tightness of the air pipe. * The suction valve might be leaking or blocked – clean the suction valve. * The suction height may be too high – check the suction height.
What to do if the Espina Water System has too low delivery?
If the Espina Water System has too low delivery, check the suction height, as it might be too high. Also, the suction housing might be dirty and require cleaning. A harmful substance might be decreasing pump output, so you should clean the pump and change any worn parts.
What to do if Espina ESP050 Water System pump switches on at low water intake?
If the pump of your Espina Water System switches on at low water intake, this can be caused by insufficient air pressure. Increase the air pressure to 1.3 bar by pumping air into the valve.
Why does thermostatic switch shuts down the Espina Water System pump?
The thermostatic switch might be shutting down the Espina Water System pump because the motor is overloaded, or foreign matter in the system is causing friction. To resolve this, dismount and clean the pump, and take steps to prevent foreign matter from entering the system.
General| Brand | Espina |
|---|---|
| Model | ESP050 |
| Category | Water System |
| Language | English |
To Next Page