24. To change the position of the canopy, hold its top part and adjust it to the
requiredposition.
25. To additionally enlarge the canopy, unzip the zipper in the back part (1) and unfold the
canopy (2).
26. To have access to the ventilation system of the canopy, enlarge it, unzip the zipper
inthe back part (1) and move the fabric (2).
SHOULDER STRAPS LENGTH ADJUSTMENT
27. Pull out the free end of the strap to remove any loose part.
28. Pull the fastener (1) to loosen the tension of the shoulder straps. Adjust the length of the
hips and crotch straps using the fasteners (2)
BUCKLE MANUAL
29. The stroller is equipped with a magnetic buckle. To unbuckle
the buckle, press both buttons of the buckle located on both sides at the same time and
remove one part from the other one.
HOW TO LOCK THE BUCKLE
30. Insert the strap fastening mechanism in the back part of the buckle. Repeat
on the other side.
31. Attach two parts of the buckle with one other.
32. Attach the front part of the buckle with the back part until you hear the clicking sound.
Check if the buckle is properly locked in place.
ASSEMBLY / ADJUSTMENT OF THE SAFETY BELTS HEIGHT
33. To assemble / To adjust the height of the seat belts, take them out of the openings in
thebackrest/seat unit and the upholstery and insert through openings in the upholstery
andthe seat unit/backrest at the desired height.
NOTE! Before locking the child with the seat belts, make sure that the seat belts are
properly assembled.
34. To use an additional harness, fix it on plastic rings located on the strollers belts.
FOOTMUFF
35. Insert the footmuff on the footrest, place it below the bumper bar and fix with snap
fasteners to the belts in the upholstery.
MOSQUITO NET FOR THE SEAT UNIT
36. Unzip the zipper below the stroller canopy (1) and take the mosquito net off. Fix the
lowerpart of the mosquito net on the footrest of the seat unit (2) and fix its lateral part to
thecanopy with a plastic ring (3).
HANDLE LENGTH ADJUSTMENT
37. Press the button on the handle (1) andsimultaneously adjust it to the required height
(2).
FOLDING THE STROLLER
38. Unlock the front wheels, disassemble the seat unit and fold the canopy. Press the
buttons of the locking mechanism located on both sides of the guide bar of thestroller (1)
and pull the handles of the locking mechanism up (2).
39. Lower the handle at the same time (1). Insert the front part of the frame to the middle
part of the stroller (2).
40. Make sure that the locking mechanism secured the stroller against accidental
unfolding.
To Next Page
Loading...
