POP
UNFOLDING THE STROLLER
2. Press the locking mechanism blockade (1), then press the locking mechanism (2)located on
the stroller handle.
3. Unfold the stroller pulling the handle up until locks on both sides of the strollerare locked in
place.
NOTE! Make sure that the stroller is properly unfolded.
ASSEMBLY OF FRONT AND REAR WHEELS
4. Insert front set of the wheel onto the hub until it is locked in place. Make sure the wheel is
properly secured. Repeat on the other side.
5. Insert rear set of the wheel onto the hub until it is locked in place. Make sure the wheel is
properly secured. Repeat on the other side.
DISASSEMBLY OF THE WHEELS
6. Press the button of the locking mechanism (1) and simultaneously take the front wheel off the
hub (2).
7. Press the button of the locking mechanism (1) and simultaneously take the rear wheel off the
hub (2).
BUMPER BAR
8. To assemble the bumper bar, insert it into plastic openings on both sides of thestroller frame
until you hear the sound of the locking mechanism. Repeat on theother side. Make sure the
bumper bar is properly secured against sliding out.
9. To detach the bumper bar, press the button of locking mechanism (1) anddetach it from the
openings in the stroller frame (2)
FOOTREST ADJUSTMENT
10. To lift the footrest, lift its end part.
11. To lower the footrest, press the handle of the locking mechanism (1) and lower the footrest.
BACKREST ADJUSTMENT
12. To lower the backrest, lower the buttons of the backrest locking mechanism (1)
andsimultaneously lower the backrest (2) to the desired position.
13. To lift the backrest, hold the end of the belt of the adjusting mechanism (1)
andsimultaneously push the backrest to the required position (2).
CANOPY MANUAL
It is possible to adjust the position of the canopy by locking it in a place with a zipper.
14. To enlarge the canopy, unzip the zipper.
15. To change the position of the canopy, hold its top part and adjust it to therequired position.
To Next Page
Loading...
