PARKING DEVICE (brake)
16. Press the break pedal with the foot to lock the rear wheels.
17. Press the break pedal with the foot to unlock the rear wheels.
VENTILATION
18. Remove the zippers from the ventilation (1). Roll the fabric and attach it to the edge
of the canopy (2)
FOLDING THE STROLLER
19. Press the locking mechanism blockade (1) and press the folding mechanism (2). Push the
handle forward at the same time (3).
20. Make sure that the stroller is properly secured against accidental unfolding.
SHOULDER STRAPS LENGTH ADJUSTMENT
21. Pull out the free end of the strap to remove any loose part.
22. Pull the fastener (1) to loosen the tension of the shoulder straps. Adjust the length of the
hips and crotch straps using the fasteners (2)
BUCKLE MANUAL
23. The stroller is equipped with a magnetic buckle. To unbuckle the buckle, press both buttons
of the buckle located on both sides at the same time and remove one part from the other one.
HOW TO LOCK THE BUCKLE
24. Insert the strap fastening mechanism in the back part of the buckle. Repeat
on the other side.
25. Attach two parts of the buckle with one other.
26. Attach the front part of the buckle with the back part until you hear the clicking sound.
Check if the buckle is properly locked in place.
ASSEMBLY / ADJUSTMENT OF THE SAFETY BELTS HEIGHT
27. To assemble / To adjust the height of the seat belts, take them out of the openings in
thebackrest/seat unit and the upholstery and insert through openings in the upholstery andthe seat
unit/backrest at the desired height.
NOTE! Before locking the child with the seat belts, make sure that the seat belts areproperly
assembled.
COVER
28. Insert the cover on the footrest and attach it with press studs on both sides of the seat unit.
To disassemble the cover, proceed in revers order.
To Next Page
Loading...
