Need help?Do you have a question about the Espressif ESP32-WROOM-DA and is the answer not in the manual?
General| Chipset | ESP32-D0WD-V3 |
|---|---|
| CPU | Dual-core |
| Clock Speed | 240 MHz |
| Flash Memory | 4 MB |
| SRAM | 520 KB |
| Wi-Fi | 802.11 b/g/n |
| UART | 3 |
| I2C | 2 |
| PWM | 16 channels |
| Touch Sensors | 10 |
| Hall Effect Sensor | Yes |
| Microcontroller | ESP32 |
| Architecture | Tensilica Xtensa 32-bit LX6 |
| Bluetooth | Bluetooth 4.2 |
| Operating Voltage | 3.0 - 3.6 V |
| Operating Temperature | -40 ~ +85 °C |
| ADC | 12-bit ADC |
| DAC | 2-channel 8-bit DAC |
| Interfaces | GPIO, I2C, SPI, UART, ADC, DAC |
Detailed overview of the ESP32-WROOM-DA module's capabilities, features, and specifications.
Details the pin layout, pin numbers, types, and functions for the ESP32-WROOM-DA module.
Lists necessary hardware/software and guides on physically connecting the ESP32-WROOM-DA module.
Instructions for installing ESP-IDF, necessary tools, and setting up environment variables.
Steps to start, configure, and build your first project on the ESP32-WROOM-DA module.
Details how to flash the compiled firmware onto the ESP32-WROOM-DA module.
Guides on using the IDF Monitor to check running application output and diagnostic logs.
Details FCC Part 15 compliance, device operation conditions, and measures to handle radio interference.
Specifies RF radiation exposure limits and required antenna separation distances for safe operation.
Outlines conditions for integrating the module into host products, including antenna placement and labeling.
Links to technical manuals, developer resources, product information, and contact details.
To Next Page
