16
II. Empty System Func on
The empty system func on is recommended to be used before a long period of non-use, frost protec on and
before taking to repair agent.
1. In standby mode, press and hold the Power ON/OFF Bu
on
and Lungo bu on together for 5
seconds.
2. The Empty System Func on icon will be ashing.
3. Remove the water tank from the appliance. Empty System Fun on icon Solid icon will appear
ind
ng that the empty system is under process. You can press the Power ON/OFF Bu on
before
removing the water tank to resume back to the standby mode.
4.
When the empty system fun on is completed, the appliance will switch o tom lly
IMPORTANT: Before using it again,
ll the water tank, then press the hot water icon un l a con nuous
stream of water comes out from the steam nozzle. This will once again prime the pump and the co
ee maker
is ready for use.
III. Manual Rinsing
You can perform a manual rinsing cycle to clean the adjustable co e nozzle a er use. It is also suggested to
perform a manual rinsing if the appliance has not been used for a long period of
me.
1. In standby condition, press and hold the Power ON/OFF
on
and hot water bu on
together.
2. Hot water bu on will be ashing. A small amount of water will be rst dispensed from the steam nozzle,
and then the coffee nozzle for the rinsing.
Danger: Water coming out from the steam and co
ee nozzles is hot and is collected in the drip
tray underneath. Avoid contact with splashes of water.
3. After rinsing, the appliance will return to the standby mode.
IV. Cleaning the Appliance
1. Power o the unit and wait for all to come to a complete rest. Then disconnect the power cord from the
power supply (electrical outlet).
2. Remove the front tray and empty out any co
ee and or water from the tray
3. Use a damp cloth or non-scratching cleaner to clean the water stains on the appliance.
IMPORTANT: Never use any abrasive, vinegar or descaling agents not included to clean the appliance.
To Next Page
Loading...
