45
IMPORTANT: Crown must be in position 1,
and all 3 chronograph hands must be at 60
(zero) before stopwatch is started. Do not
use chronograph while crown is pulled to
position 2 or 3. If necessary, press button B
to reset chrono hands to zero before you
start timing. If hands do not move to zero
position after button B is pushed, follow
instructions below for synchronizing hands.
To operate Chronograph with Compass
Feature:
Simple chronograph functions:
To measure the duration of a single, non-
stop event:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph, and read the 3 chronograph
hands to determine elapsed time, for example:
0 hours, 28 minutes, 14 seconds.
3. Press button B to reset chronograph to zero.
To Next Page
Loading...
